Wireless light actuator 10A/250V AC. Impulse switch with 1 normally open contact, not potential-free. 230V LED lamps and ESL up to 200W, 230V incandescent and halogen lamps 1000W. Standby loss only 0.4 watts. For built-in installation. 49x51mm, 20mm deep. The connection terminals are plug-in terminals for conductor cross-sections from 0.2mm² to 2.5mm². Up to 32 wireless universal buttons, wireless direction buttons, wireless central control buttons and motion sensors can be taught in using the convenient tap technology. Bidirectional radio can be activated. Contact switching at zero crossing. Supply, switching and control voltage locally 230V. If the supply voltage fails, the switch position is retained. When the supply voltage returns, the switch is switched off in a defined manner. After installation, wait for the short automatic synchronization before connecting the switched consumer to the mains. In addition to the radio control input via an internal antenna, this radio actuator can also be controlled locally with a conventional 230V control button or switch that may be mounted in front of it. A glow lamp current is not permitted.
