Benning MM 6-2 True RMS digital multimeter. Digital display. Analogue bar graph. 4-digit LCD display (6000 points). With screen backlight. Smallest resolution for direct voltage 0.1 mV. Max. voltage measuring range DC 1000 V. Smallest resolution for alternating voltage 0.1 mV. Max. voltage measuring range AC 1000 V. Smallest resolution for direct current 1000 µA. Max. current measuring range DC 10 A. Smallest resolution for alternating current 1000 µA. Max. current measuring range AC 10 A. Smallest resolution for resistance 0.1 Ohm. Max. resistance measuring range 40 MOhm. Smallest resolution for capacitance 0.001 µF. Max. capacitance measuring range 10000 µF. Capacitance measurement yes. Smallest resolution for frequency 0.01 Hz. Max. frequency measuring range 100 kHz. Frequency measurement yes. Continuity test/diode test yes. Continuity test (20 Ohm) (red LED/buzzer)/diode test (1.5 V). True RMS measurement (TRMS) yes. AutoV function for automatic AC/DC voltage detection. Low input impedance (LoZ) to suppress capacitive/inductively stray voltages. Integrated volt sensor signals phase voltages and cable breaks in lines without contact (optical/acoustic). Single-pole phase test. Automatic measuring range selection. Automatic switch-off. Automatic low battery voltage display. Instantaneous value memory (data hold) yes. Peak value memory PEAK. Relative value measurement REL. Measuring circuit category Cat IV. Max. voltage measuring circuit category 600 V. Measuring circuit category Cat III. Max. voltage measuring circuit category 1000 V. Includes rubber protective frame with magnetic hanger, bag, 9 V block LR61 battery, test leads, fuse 11 A (10218772).
| Property | Value |
| Max. voltage measuring range AC: | 1000 V |
| Measuring range selection: | automatic |
| Display: | digital |
| With level measurement (dB): | no |
| Frequency measurement: | yes |
| Capacitance measurement: | yes |
| Analog bar display: | yes |
| Multiple display: | no |
| Smallest resolution AC voltage: | 0.1 mV |
| Max. Voltage measuring range DC: | 1000 V |
| Smallest resolution direct voltage: | 0.1 mV |
| Max. current measuring range AC: | 10 A |
| Smallest resolution alternating current: | 1000 µA |
| Max. current measuring range DC: | 10 A |
| Smallest resolution direct current: | 1000 µA |
| Max. Resistance measuring range: | 40 MOhm |
| Lowest resistance resolution: | 0.1 Ohm |
| Continuity test/diode test: | yes |
| Relative value measurement: | yes |
| Inductance measurement: | no |
| Conductance measurement: | no |
| Instantaneous value memory (data hold): | yes |
| Maximum value memory: | no |
| Minimum value memory: | no |
| Peak value memory: | yes |
| True RMS measurement: | yes |
| Duty cycle measurements: | no |
| Measured value memory: | no |
| Interface: | no |
| Measuring circuit category: | CAT IV |
| Analog bar display analog/logarithmic: | no |
| Bluetooth interface: | no |
| Speed measurement: | no |
| Continuity test: | yes |
| Explosion-tested version: | no |
| IR interface: | no |
| Cable length measurement: | no |
| Smallest resolution frequency: | 0.01 Hz |
| Smallest resolution capacitance: | 0.001 µF |
| Smallest resolution temperature: | other |
| Power and energy measurement: | no |
| Line symmetry test for two-wire connections abE: | no |
| Max. frequency measuring range: | 100 kHz |
| Max. Capacitance measuring range: | 10000 µF |
| Max. Voltage measuring circuit category: | 600 V |
| Milliohm measurement with 4-wire technology (Kelvin connection): | no |
| Nominal test voltage 10 V: | no |
| Nominal test voltage 100 V: | no |
| Nominal test voltage 1000 V: | no |
| Nominal test voltage 250 V: | no |
| Nominal test voltage 50 V: | no |
| Nominal test voltage 500 V: | no |
| Harmonics analysis/Power Quality: | no |
| Circuit breaker: | no |
| Temperature measurement RTD: | no |
| Temperature measurement TC: | no |
