Benning CM 10-PV True RMS current clamp multimeter for photovoltaic systems, heating, ventilation and air conditioning technology as well as service and industry. Digital display. 4-digit LCD display (6000 points). With screen backlight. Voltage measurement/AC 0.1 V - 1500 V. Voltage measurement/DC 0.1 mV - 2000 V. Voltage measurement up to 1500 V AC/ 2000 V DC via TA PV measuring adapter. Current measuring range/AC 0.000001 A - 600 A. Current measuring range/DC 0.000001 A - 600 A. Current type direct/alternating current. Microampere and temperature measuring range for heating, ventilation and air conditioning technology. Resistance measuring range 0.1 Ohm - 600 kOhm. Continuity test yes. Diode test yes. True RMS measurement (TRMS) yes. Frequency measurement 0.01 Hz - 10 kHz. Frequency measurement yes. Capacitance measurement 0.1 F - 1 mF. Capacitance measurement yes. Temperature measurement - 40 °C - + 400 °C. Temperature measurement yes. Data logger and storage function (4000 measured values). Bluetooth Low Energy 4.0 interface for measured value transmission. Free IOS and Android app BENNING MM-CM Link for downloading, saving and sharing measured values via smartphone/tablet. INRUSH inrush current measurement for measuring inrush currents (motors etc.). Low-pass filter (HFR high frequency suppression, 800 Hz) for measurements on clocked motor drives. Measuring input for flexible current transformer BENNING CFlex 1 to 3000 A AC (option). Volt sensor for contactless phase and cable break testing (red LED). Automatic measuring range selection. Automatic shutdown. Automatic battery undervoltage display. Instantaneous value memory Hold. Maximum value memory MAX. Minimum value memory MIN. LED measuring point illumination. Clamp opening 37 mm. Measuring circuit category Cat IV. Max. voltage measuring circuit category 600 V. Measuring circuit category Cat III. Max. voltage measuring circuit category 1000 V. Non-slip and break-proof SoftGrip housing. Includes BENNING TA PV measuring adapter, measuring lead/crocodile clip set, case, wire temperature sensor, 2 x 1.5 V Mignon/AA/LR6 batteries.
