Blister pack shading with radio button F2T55E and radio actuator for shading elements and roller shutters FSB61NP-230V. Smart home sensor and smart home actuator. F2T55E: radio button pure white glossy with print for individual installation 80x80x15mm or installation in the E-Design55 switch system. Generates the energy for radio telegrams even when the button is pressed, therefore no connection cable and no standby loss. Radio buttons with a rocker can send two evaluable signals: press the rocker up and press the rocker down. The mounting plate can be screwed onto a flat surface or stuck to the wall, glass or furniture with the included adhesive film. The sleeves in the box are used for screw fastening over a 55 mm switch box. FSB61NP-230V: Radio actuator for shading elements and roller shutters 1+1 normally open contact not potential free 4A/250V AC. Encrypted radio, bidirectional radio and repeater function can be switched on. Standby loss only 0.8 watts. For built-in installation. 45mm long, 45mm wide, 33mm deep. Local supply, switching and control voltage 230V. If the supply voltage fails, the device is switched off in a defined manner. In addition to the radio control input via an internal antenna, this radio actuator can also be controlled locally with a conventional 230V control button that may be mounted in front of it.