The OBO small distributor series ensures safe power distribution indoors and outdoors. The surface-mounted small distributors meet all the requirements of IEC 439-3 and are available in four different sizes with three to twelve division units. There are three equipment variants: with screw terminals, with plug-in terminals and without terminals. All sizes and equipment variants are available in two materials. All small distributors are supplied with a pre-assembled 35 mm hat profile support rail. The small distributors with terminal strips also contain an accessory set that includes a sticker sheet. The self-adhesive pictograms make the often annoying labeling of the individual division units superfluous. Should labeling be necessary, there are also corresponding stickers on the sticker sheet. The high protection class (IP66) and the robust construction (IK07 at -25C) ensure safe operation even in difficult environmental conditions. The increased distance between the top hat profile support rail and the small distribution board rear wall makes wiring much easier: cables and lines are easily and quickly routed behind the built-in devices. The cables can be introduced into the interior of the small distribution board from above, below and from the back, which further simplifies wiring and improves the appearance of the housing.Surface-mounted small distribution board, protectively insulated for max. 5 division units. 5 breakout openings on the top and bottom (4x 20 and 1x 20/25) including pre-assembled 35 mm top hat profile support rail. The four screw caps supplied prevent unwanted voltage transfer. The PC small distributors are suitable for indoor and outdoor installation.
