Electric small instantaneous water heater, electronically controlled MCX 3: 3.5kW 230V (approx. 2.0 l/min 35 to 45°C) with Schuko plug Electronically controlled small instantaneous water heater with effective bare wire heating system for energy-efficient hot water supply to a point of use, especially a hand wash basin. The small, elegant device heats the water directly as it flows through, without using standby energy. The electronics automatically regulate the power so that the preset outlet temperature is not exceeded. Together with the economically adjusted flow rate, the device ensures maximum efficiency. Description: Electronically controlled instantaneous water heater (under-counter device) in mini format for supplying a hand wash basin or a tea kitchen Saves up to 85% energy compared to conventional small storage tanks Power electronics to regulate the heating output for demand-based hot water preparation Effective bare wire heating system IES® Pressure-resistant design Removable cover for access to the central cover screw and water quantity adjustment Ready to plug in (3.5 kW) or power cable (from 4.4 kW), length: 650 mm Special jet regulator for use in jet regulator thread M 22/M24 Connection set (T-piece and flexible pressure hose) for an angle valve is included in delivery The control panel with the sensor button and three colored LEDs is used to set the maximum outlet temperature to 35 °C, 38 °C or 45 °C Areas of application: With commercially available sanitary fittings for hand wash basins, also suitable for touchless fittings for pillar taps (no mixing of hot and cold water necessary) if scalding protection is required with low flow water pressure for reheating preheated water (e.g. solar) for a kitchen sink (only MCX 6/7) Technical information: TypeMCX 3 Clage article number:15003 Nominal capacity liters:0.2 Permissible operating pressure MPa (bar) :1 (10) Water connections (screw connections) :G 3/8 Hot water output at t = 25 K l/min: 2.0 Switch-on max. flow rate l/min: 1.2 2.0 Nominal output kW: 3.5 Voltage V: 1 / N / PE ~ 220 240 Nominal current A: 15 Required cable cross-section mm2: 1.5 Test mark/ protection class: yes/ IP 25 IES® bare wire heating system / cm: yes/ 1100 Suitable for solar systems (inlet temp. < 70 °C): yes Approx. weight with water filling kg: 1.5 Dimensions (HxWxD): 13.5 18.6 8.7 cm