Thanks to its galvanized sheet steel housing, the 1-pole mechanical built-in thermostat is very robust and can also be used under harsh conditions. The measuring system used works according to the liquid expansion principle and can be used without any problems up to a maximum permissible sensor temperature of 230 °C. The smooth round sensor made of copper has a diameter of 6 mm and a sensor length of approx. 113 mm. The thermostat's long-distance line is also made of copper and can be laid flexibly, provided a bending radius of 5 mm is observed. The maximum permissible ambient temperature on the switching head (protection class IP00) is 80 °C. The switching head is attached using a mounting bridge with two M3 x 22 screws. Using a setpoint adjuster, which is available as an accessory, the desired switch-off temperature can be easily set on a scale. The temperature controller is characterized by a high switching point accuracy of +/- 1.5% in the upper third of the scale. A decisive advantage is that no additional auxiliary power is required for temperature measurement. The electrical connection is made to the flat plugs (A 6.3 x 0.8 DIN 46244) of the switch set, which can directly switch a maximum permissible switching capacity of AC 230 volts / 16 A. The thermostat has a switching difference (hysteresis) of 2.5% of the scale range and automatically switches back to the original state when the switch-off temperature falls below this value. The temperature controller is very flexible and is used in heating, air conditioning and ventilation technology as well as in the plastics industry, apparatus and furnace construction and for temperature monitoring in laboratories and climate cabinets. The device is approved according to DIN EN 14597 and has UL and EAC approval.
