Powerline dimming actuator 1-10V. 53x43mm, 25mm deep, for installation in 58mm switch boxes. For switching and/or dimming via a 1-10V interface. 1 normally open contact not potential-free 600VA. Standby loss only 0.5 watts. For controlling and dimming at different locations. Current sink of max. 30mA for active and passive electronic ballasts. A powerline sensor input is required for control. There are two rotary switches on the front for address assignment: The left rotary switch determines the group address g with 16 alphabetical values from A to P. The right rotary switch determines the element address e with 16 numerical values from 0 to 15. Above this is a slide switch, which has no function here. All entries and configurations can be accessed via the Sienna-Professional PC software, even when the power is connected. Minimum and maximum brightness can be changed using SIENNA-Professional. To the left of the rotary switches there is a red LED that shows all activities. Next to it is the reset button and to the right of it is a service pin. Functions as per the operating instructions. The connection terminals at the top are plug-in terminals for conductor cross-sections from 0.2mm² to 1.5mm².
