Wireless DALI gateway, bidirectional. Standby loss 2 watts. Can be installed in suspended ceilings and lights, for example. 252mm long, 46mm wide and 31mm deep. With cable strain relief. Supply voltage 230V on terminals N and L. 16V DC/130mA is provided on the DALI +/- terminals for up to 64 DALI devices. The FDG71L gateway is used to control DALI devices with EnOcean radio transmitters. Groups 0-15 can be controlled and the broadcast command can also be sent. DALI scenes 0-15 can also be controlled. DALI installations that are to be completely controlled with the FDG71L must therefore be configured in groups 0-15. The configuration software or control modules for this are offered by well-known manufacturers of DALI components (e.g. Tridonic DALI XC). The FGD71L internally stores the dimming value for each of the groups 0-15 and provides this value as feedback. The same feedback telegrams are generated as with a FUD71. The feedback from the device addresses corresponds to the dimming values of the DALI groups 0-15 in ascending order. The feedback can be switched individually for each group using PCT14 from dimming value telegram (%) to button telegram (on/off). This means that actuators can be controlled using the feedback. The FDG71L fulfills the functions of the DALI master and the DALI power supply. Attention: Radio buttons always require a double click when manually teaching them into the FDG71L! With CLR, a single click is sufficient. A direction button or universal button with the same ID and the same button cannot be taught into different groups multiple times. The last selected group always applies. A button can therefore either switch just one group or all groups with broadcast. One underfloor heating system can also be programmed into each group. When programmed manually, this always works regardless of the brightness. The brightness threshold can also be set using PCT14. The delay time for switching off after no movement can be set together in minutes (1..60) for the underfloor heating systems of all groups. The default is 3 minutes.
