Set wind and brightness automatic Soliris RTS With the radio receiver Universal Receiver RTS you can upgrade your wired awning motor with RTS radio. Thanks to the sensor supplied, your awning motor can be controlled manually using a hand-held transmitter or depending on the wind and brightness. Product features of the radio receiver: Up to 3 sensors and 12 RTS transmitters can be programmed into the radio receiver Two my positions can be programmed and called up using the radio transmitter: one from the upper and one from the lower end position of the awning 230V connection option for the Soliris Sensor RTS LED radio wind and brightness sensor Easy programming of the sensors using a button directly on the radio receiver Integrated test button in the radio receiver Quick connection terminals for the power cable and drive Product features of the Telis Soliris RTS radio handheld transmitter: 1-channel radio handheld transmitter Individual, group or central operation possible Manual control of one or more RTS radio receivers, transmitter my button for stopping or moving to the set intermediate positions UP button: Open the roller shutter, retract the awning, switch on the light DOWN button: Close the roller shutter, extend the awning, switch off the light Button for channel selection LED for transmission and battery status display and for automatic sun control ON, OFF Programming button on the back of the Radio hand-held transmitter Wireless, battery-operated Hanging eyelet and wall bracket for flexible installation Increased shock resistance due to built-in rubber on the side edges Product features Radio wind and sun sensor Soliris Sensor RTS LED: Measurement of wind speed and brightness value via the integrated wind-sun sensor Blinds move into the protective position if the set wind value is exceeded If the wind value is not reached: Radio motors are released after 12 minutes Blinds extend (if the brightness value is exceeded) to the preset intermediate position Easy setting of the wind and brightness value on the sensor LED status display if the wind and brightness value is exceeded Programming button on the sensor Wireless communication to the radio motor, receiver Demo mode for time-saving function testing Installation via 230V connection
