WALTHER E-Mobility accessories, EV tester / simulator as service case, with load simulation up to 6A, size: 190 x 400 x 310mm / HxWxD, With the EV tester / simulator, the functions of charging devices for electric vehicles (charging stations, wall boxes, etc.) and plug-in charging cables (Mode 3) can be tested by simulating the electric vehicle. , Functions:, - Measurement of the coding resistance (PP) of the coupling type 2, - Measurement of the proximity control resistance (CS) of the coupling type 1, - 4 cable codings (13/20/32/63A) adjustable via toggle switch, in conjunction with the measuring cable (special version), - Checking the PE connection between PWM and vehicle, - Simulation of a fault current >30mA from L1 to PE, - Simulation of vehicle status B, C, D and display, - Charging voltage (L1, L2 and L3) via 3 LEDs, - Measuring socket CP for PWM signal, - Load simulation via protective contact sockets max. 6A (L1), - 5 measuring contact sockets (L1, L2, L3, N and PE), Equipment (installed on the side):, - Charger plug type 2, - Measuring contact sockets, - Charger plug type 1, - Protective contact socket with measuring cable (special version)
| Property | Value |
| Connection CHAdeMO: | no |
| Connection GB: | no |
| Connection type 1: | no |
| Connection type 1 CCS: | no |
| Connection type 2: | yes |
| Connection type 2 CCS: | no |
| Connection type 3: | no |
| Design: | Case |
| Width: | 400 mm |
| Weight: | 4800 g |
| Height: | 190 mm |
| Measurement of resistances of charging connector: | yes |
| Signal output: | yes |
| Simulation of vehicle status: | yes |
| Simulation of fault current: | yes |
| Simulation conductor cross-section: | yes |
| Charging status display: | yes |
| Test PE connection: | yes |
| Depth: | 310 mm |
