Up to four channels can be controlled with the DALI wall panel. Since it is an RGBW wall panel, four DALI addresses are required per channel. The different colors can be set using the touch wheel, and the colors red, green, blue and white can also be switched on and off individually. In addition to the ten saved color change programs, it is possible to save up to four light scenes per channel. Dimming is of course also possible with the panel. Since the wall panel functions as a BUS transmitter, the use of the DALI base station is optional, but not absolutely necessary. When operating as a BUS transmitter (without DALI base station), the connection is made to 230V, whereby a maximum of 50 participants can be controlled via one wall panel. In addition, 3 further wall panels can be integrated into the system, which are operated via the BUS voltage of the first wall panel (BUS transmitter). When operating with the DALI base station, a maximum of 4 wall panels can be used per base station. The wall panels must not be operated via 230V, but only via the BUS voltage of the DALI base station. It is also possible to operate two wall panels via 230V in one system, with only one of the wall panels acting as a BUS transmitter. This allows up to 100 participants (50 per panel) to be controlled. Two additional wall panels can be integrated into this system via the BUS voltage, whereby the number of controllable participants remains unchanged. Installation on switch boxes is possible without any problems. Please note: The panel sends a broadcast command which switches all components within a BUS system to linear dimming. This function cannot be switched off.
